Filter
Top Products
33
ENGLISH
(1) Before playing with the surround function
•Adjustments using the test tones can only be performed in the
“Auto” mode and are only valid for the AUTO DECODE Surround
modes. The adjusted levels are automatically stored in the memory.
10
SURROUND PLAYBACK
•Even after adjusting using the test tones, the various channels can
be adjusted using the procedure described below to suit the
program source and your preferences.
1, 4
2
33
42, 4
1, 3
1
Press the TEST TONE button.
Remote control unit
2
Test tones are output from the different speakers.
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
Main unit
+
-
Remote control unit
3
Use the channel volume adjust buttons to adjust so that the
volume of the test tones is the same for all the speakers.
•The ( and ) cursor buttons on the remote control unit
during the adjustments using the test tones.
Remote control unit
4
After adjusting using the test tones, adjust the channel levels
either according to the playback sources or to suit your tastes,
as described below.
Remote control unit
1
Press the CH.SELECT button on the remote control unit.
•The following is displayed:
Remote control unit
2
Use the select button while the above is displayed to
select “LEVEL”.
•The level display shown below appears.
Remote control unit
3
Select the speaker whose level you want to adjust.
•The channel switches as shown below each time the button
is pressed.
Remote control unit
4
Adjust the volume level of the selected speaker while the
channel level is displayed.
LLEVE </ LD>E YA
FOL V L< B0 d >
Remote control unit
Once the channel level setting is completed, select “END” at step
3. The display returns to normal after several seconds.
END
SUBWOOFER
SURROUND RSURROUND L
FRONT L CENTER FRONT R