Filter
Top Products
37
ENGLISH
4
Select and set the surround
parameters.
(On the remote control unit, use the
, cursor buttons to set the
parameters.)
If nothing is done for 4 seconds
from when the parameter is
displayed, the normal display
reappears.
Main unit
B Setting the DOLBY VS mode
2SP Ref. 2SP Wide
The mode is not displayed if it cannot be selected.
Remote control unit
Surround parameters (2)
DOLBY VS (Dolby Virtual Speaker mode)
• REF (Reference mode)
This is the standard mode.
• WIDE (Wide mode)
This mode expands the front channel sound field.
NOTES:
•Press the VIRTUAL button on the remote control unit during
playback in the Dolby Virtual Speaker mode to switch between
the 2-speaker, 3-speaker and 5-speaker modes.
2- and 3-speaker modes :The reference and wide modes can be
selected for the sound field of the
front 2-channel speakers. This is
convenient when it is difficult to install
a surround speaker.
5-speaker mode :The sound is played in the wide mode
expanding the 5.1-channel playback
and front 2-channel speaker sound
field. This is convenient when the front
speakers cannot be moved very far
apart.
•Switch between the reference and wide modes by selecting the
surround parameters in steps 3 and 4.
(4) Playing in the DSP surround modes
• This unit is equipped with a high performance DSP (Digital Signal Processor) which uses digital signal processing to synthetically recreate the
sound field. One of 2 preset surround modes can be selected according to the program source. (Analog and PCM sources only. Except 96kHz
PCM source.)
*
1
*
2
5CH STEREO
(M. CH STEREO)
HALL
When playing recordings of live music, this mode provides a feeling similar to actually being in a concert
hall.
When this mode is selected, the normal program source is directed to the main speakers and a reverberated sound
is directed to the surround speakers.
This mode is suited to program sources which contain a large amount of reverberation.
The Front left channel signals are output to the surround and surround back signal left channels,the front right
channel signals are output to the surround and surround back signal right channels, and the in-phase component
of the left and right channels is output to the center channel.
Use this mode to enjoy stereo sound.
Personal Memory Plus
This set is equipped with a personal memorize function that automatically memorizes the surround modes and input modes selected for the
input different sources. When the input source is switched, the modes set for that source last time it was used are automatically recalled.
• Settings automatically stored in the memory for the individual input functions using the Personal Memory Plus function:
q Surround mode (including 2-channel decode mode and Dolby Pro Logic II mode settings)
w Input mode selection function
The surround parameters, SDB/P.EQ control settings and playback level balance for the different output channels are memorized for each
surround mode.
Once the surround parameters have been set, stop
operating the buttons. After several seconds, the normal
display reappears and the settings are automatically
entered.