Denon AVR-3805 Home Theater System User Manual


 
56
Learning function
If your AV component is not a Denon product or if it cannot be operated using the preset memory, it can be controlled with the accessorious
remote control unit by storing its remote control signals in the remote control unit.
For some remote control signals it is not possible to “learn” the signals or the device will not operate properly. In such cases use the remote
control unit included with the device to operate it.
3, 7
3
1, 8
2
1
Press the power ON button and the OFF button
simultaneously.
2
Press the “2” button to select
Learning setup.
3
Press the Mode button for the component you want to
learned, then press the ENTER button.
Learning is not possible for the AMP, ZONE2, and ZONE3
modes.
4
Buttons that allow learning will light. Press the button that you
wish to be learned. The display will go off and the unit will
enter the learning standby mode.
5
Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to “learn”.
6
“OK” appears on the remote control unit’s display and
learning is completed.
Other keys can be “learned” by repeating steps 5 to 6.
“FAIL” appears on the remote control unit’s display,
repeating steps 4 to 6.
7
The mode can be switched by pressing a mode selector
button.
The “Buttons that allow learning” display reappears and the
learning standby mode is set.
Other remote
control unit
8
To cancel the learning mode, press the power ON button and
the OFF button simultaneously again.
To cancel, press the power ON
button and the OFF button
simultaneously.
CH SEL
ENTER