Filter
Top Products
24
1-1 Setting the Auto Setup
3
Check the "Power Amp Assign" setting.
• When “Surround Back" is selected, the test tone during Auto Setup will be output from the Surround Back speaker.
• When “ZONE2” or “ZONE3” is selected, change the setting to "ZONE2” or "ZONE3". The test tone during Auto Setup is set so that
it will not be output to ZONE2 or ZONE3 (Another room).
1
Select “Auto Setup” at the Auto Setup / Room EQ
Menu.
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
Auto Setup
*AutoSet/RoomEQ
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
q Select the Power Amp Assign setting.
w Select “Surround Back”, “ZONE2” or “ZONE3”.
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
P.Amp: SB
*Auto Setup
4
q Select the “Start”.
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
Start
*Auto Setup
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
2
Display the Auto Setup screen.
w Press the Cursor left button.
NOTE:
• When “ZONE2” or “ZONE3” is selected at System
Setup Menu “Power Amp Assign”, surround back
speaker is not displayed as the target of setup in “2-
1.setting the type of speakers. The results is reflected
in “5-1.Power Amp Assign”.