Filter
Top Products
45
Make this setting to switch the power amplifier for the surround back channel to ZONE2 or ZONE3.
If ZONE2/3 is selected, the signal that selected at ZONE2/3 is output at “SURR. BACK/MULTI ZONE PREOUT” terminals.
1
Select “Power Amp Assignment” at the Option
Setup Menu.
3
Select “Surround Back” to use as the surround back
channel, “Zone2” to use as Zone2 out, Zone3 to use as
Zone3 out.
When “Surround Back” is selected When “Zone3” is selected
5-1 Setting the Power Amplifier Assignment
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
P.Amp Assign
*Option Setup
S.Back
*P.Amp Assign
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
4
Enter the setting.
The Option Setup Menu reappear.
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
2
Press the ENTER button.
Display the Power Amp Assign screen.
2
Display the Zone2 vol. Level screen.
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
Set the Zone2 pre-out output level adjustment.
1
At the Option Setup Menu select “Zone2 vol.Level”.
5-2 Setting the Zone2 vol. Level
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
Zone2 Vol.Level
*Option Setup
When “Zone2” is selected