Denon AVR-3805 Home Theater System User Manual


 
32
2-1
Setting the type of speakers
The composition of the signals output to each channels and the frequency response are adjusted automatically according to the combination of
speakers actually being used.
1
CH SEL
ENTER
Select Speaker Configuration at the Speaker Setup
Menu.
2
3
CH SEL
ENTER
Display the speaker configuration screen as below.
Set whether speakers are connected or not and, if so, their size parameters.
q Select the speaker
w Select the parameter
4
ENTER the setting.
The Speaker Setup Menu reappears.
NOTE:
Select Large or Small not according to the actual size of the speaker but according to the speakers capacity for playing low frequency
(bass sound below the frequency set for the Crossover Frequency) signals. If you do not know, try comparing the sound at both settings
(setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
Surround back Sp.
Surround Sp. B
(Main unit)
(Remote control unit)
CH SEL
ENTER
Speaker Config.
*Speaker Setup
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
FrontSp: Large
*Speaker Config
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
Parameters
Large...................Select this when using speakers that have sufficient performance for reproducing bass sound below the frequency set for the
Crossover Frequency mode.
Small...................Select this when using speakers that do not have sufficient performance for reproducing bass sound below the frequency set
for the Crossover Frequency mode. When this is set, bass sound with a frequency below the frequency set for the Crossover
Frequency mode is sent to the subwoofer.
None……............Select this when no speakers are installed.
Yes/No.............Select Yes when a subwoofer is installed, No when a subwoofer is not installed.
2spkrs/1spkr.......Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when Small is set for the front, center
and surround speakers.