39
3-1
Setting the Digital In Assignment
• This setting assigns the digital input jacks of the AVR-3805 for the different input sources.
1
2
3
4
At the Input Setup Menu select “Digital In
Assignment”.
Display the Digital Inputs screen.
Select the digital input jack to be assigned to the input source.
q Select the input source
Enter the setting.
The Input Setup Menu reappears.
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
Digital In
*Input Setup
CD : COAX1
*Digital In
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
NOTES:
• The OPTICAL 3, 4 jacks on the AVR-3805’s rear panel are equipped with an optical digital output jack for recording digital signals on a CD
recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a digital
audio recorder.
• Do not connect the output of the component connected to the OPTICAL 3, 4 OUT jack on the AVR-3805’s rear panel to any jack other than
the OPTICAL 3, 4 IN jack.
•“PHONO” and “TUNER” cannot be selected on the Digital In Assignment.
w Select the digital input jack
Select “OFF” for input sources for which no digital input jacks are used.
If “Yes ” is selected for “Default”, the settings are automatically reset to the default
values.
Refer to “DENON LINK connections”. (See page 14)