Filter
Top Products
34
6
Set the distance between the center speaker and listening position.
The distance changes in units of 0.1 foot (0.03 meters) each time the button is pressed. Select
the value closest to the measured distance.
If “Yes” is selected for “Default”, the settings are automatically reset to the default values.
Please note that the difference of distance for every speaker should be 20 ft (6.0 m) or less. If
you set an invalid distance, a CAUTION notice, such as screen right will appear. In this case,
please relocate the blinking speaker(s) so that its distance is no larger than the value shown in
highlighted line.
When “Step” is selected, you can select the unit of “1ft (0.1m)” or “0.1ft (0.01m)”.
Example: When the distance is set to 12 feet
for the center speaker
7
Enter the setting.
The Speaker Setup Menu reappears.
The AVR-3805 automatically sets the optimum
surround delay time for the listening room.
NOTE:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 20).
2-3
Setting the Channel Level
• Use this setting to adjust so that the playback level between the different channels is equal.
• From the listening position, listen to the test tones produced from the speakers to adjust the level.
• The level can also be adjusted directly from the remote control unit. (For details, see page 72.)
• When both surround speakers A and B are used, their playback levels can be adjusted separately.
1
2
Select “Channel Level” at the Speaker Setup Menu.
Display the Channel Level screen.
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)
Channel Level
*Speaker Setup
T.Tone: Auto
*Channel Level
CH SEL
ENTER
CH SEL
ENTER
(Main unit)
(Remote control unit)