Denon AVR-3312 Stereo Receiver User Manual


  Open as PDF
of 156
 
118
SYSTEM SETUP
Language
Default settings are underlined.
Set the language for display on the menu screen.
Setting details
English / Deutsch / Français
“Language” can also be set by the following procedure. However, the menu screen is not displayed.
1. Press and hold the main unit’s PRESET 1 and PRESET 3 for at least 3 seconds.
“zVideo Format” appears on the display.
2. Press the main unit’s STATUS and set “zGUI Language”.
3. Press the main unit’s TUNER PRESET CH +, – and set the language.
4. Press the main unit’s INTERNET RADIO V to complete the setting.
Notes concerning use of “Firmware Update” and “Add New Feature”
•In order to use these functions, you must have the correct system requirements and settings for a
broadband Internet connection (vpage19).
•Do not turn off the power until updating or upgrading is completed.
•Even with a broadband connection to the Internet, approximately 1 hour is required for the updating/
upgrading procedure to be completed.
•Once updating/upgrade starts, normal operations on this unit cannot be performed until updating/
upgrading is completed.
•Furthermore, updating/upgrading the firmware may reset the backup data for the parameters, etc. set
for this unit.
•If the update or upgrade fails, press and hold the ON/STANDBY on the main unit for more than 5
seconds, or remove and re-insert the power cord. “Update retry” appears on the display and update
restarts from the point at which update failed. If the error continues despite this, check the network
environment.
•Information regarding the “Firmware Update” function and “Add New Feature” will be announced on
the DENON web site each time related plans are defined.
•When usable new firmware is released with “Firmware Update” or “Add New Feature”, a notification
message is displayed on the menu screen. When you do not want to be notified, set “Update Notification”
(vpage113) and “Upgrade Notification” (vpage113) to “OFF”.
Setting items Setting details
Maintenance Mode
Use when receiving
maintenance from a DENON
service engineer or custom
installer.
NOTE
Only use this function if so instructed by a DENON serviceperson or
installer.
Basic version
Advanced version
Information
Advanced version
BD
 previous next