Filter
Top Products
Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications
<ZONE2/3/4 /
REC SELECT>
<PHONES>
<SOURCE SELECT>
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Recording on an External Device
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <ZONE2/3/4 / REC SELECT>.
“ZONE3 SOURCE” is shown on the display.
2
Turn <SOURCE SELECT> until “RECOUT SOURCE”
is displayed.
The “ ” indicator lights.
ZONE3 SOURCE ZONE3 TUNER ZONE3 HD Radio····
RECOUT HD Radio RECOUT XM RECOUT SOURCE····
3
Turn <SOURCE SELECT> to choose the input source
to be recorded.
4
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
59).
5
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
• To cancel, press <ZONE2/3/4 / REC SELECT>, then turn <SOURCE
SELECT> until “ZONE3 SOURCE” is displayed.
• Make a test recording before starting the actual recording.
• Signals are only output to the analog REC OUT connectors when
the digital signals input to the digital input connectors (OPTICAL/
COAXIAL) are PCM (2-channel) signals.
• Digital audio signals input to the DENON LINK or HDMI connectors
are not output to the REC OUT connectors, so connect using the
OPTICAL or COAXIAL connectors.
• Sources selected with the REC OUT mode are output from ZONE3
as well.
• In the REC OUT mode, the remote control unit’s ZONE3 mode
buttons cannot be operated.
• When the “Digital Out” setting is set to “ZONE4 Select”, the
OPTICAL4 output connector becomes the ZONE4 output. When
using for recording, set to “Rec Select”.
• Copyright protected network audio (Internet radio, media server,
USB and Rhapsody) signals cannot be output from the digital output
connectors (OPTICAL).
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• When “DENON LINK” is assigned at the GUI menu “Assign” setting,
the PCM signals, network audio signals (Internet radio, media server,
USB and Rhapsody), XM signals and HD Radio signals input from the
digital input connectors cannot be output from the analog REC OUT
connectors.
• Input sources for which “Delete” is selected at “Source Delete”
cannot be selected.
Dolby Headphone recording
When REC OUT mode is set to “SOURCE”, with the AVP-A1HDCI it
is possible to output signals encoded in the Dolby Headphone mode
from the recording output terminal and record them on a separate
recorder.
1
The Dolby Headphone play mode is set when
headphones are connected to <PHONES> during
playback in the STANDARD (DOLBY/DTS
Surround) mode.
When this is done, signals encoded in the Dolby Headphone
mode are automatically output from the recording output
terminals (analog and digital) and can be recorded.
2
Select the parameters and set the desired mode.
Start recording.
Refer to the “Dolby Headphone” (vpage 51).
NOTE
Do not disconnect the headphones during recording.
Playback