Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications
Multi Zone
ZONE2 or ZONE3 Pre-out Connections
• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 or ZONE3 pre-out
(variable or fixed level) connectors can be used to play a different program source in ZONE2 or ZONE3
the same time (vpage 86, 87).
• To the monitor output of ZONE2, various formats of video signals input by the video conversion function
are automatically converted and output (vpage 9).
• To the monitor output of ZONE3, video signals input from the S video terminal or video terminal is output
(vpage 9).
• The ZONE2 (ZONE3) video out is only for ZONE2 (ZONE3).
R
L
R
L
"6%*0
3-
*/ */
7*%&0
"6%*0
R
L
R
L
"6%*0
3-
*/
"6%*0
7*%&0 7*%&0
*/
7*%&0
$0.10/&/57*%&0
: 1# 13
*/
47*%&0
*/
"69
065
ZONE2
Power
amplier
Input
Output
Infrared
retransmitter
Infrared
sensor
Extension jack for future use.
NOTE
• For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.
• For instructions on installing and operating separately sold devices, refer to the respective devices’
operating instructions.
• To conduct multi-zone playback, see “Multi-Zone Connections and Operations” (vpage 86, 87).
Monitor
"6%*0
*/
015*$"-
"6%*0
*/
015*$"-
Monitor
Power
amplier
ZONE3
ZONE2 or ZONE4 Optical Connections
The AVP-A1HDCI is equipped with Optical output connectors for ZONE2 and ZONE4. If a bit-stream amp
is rigged-up, these zones can also be used to enjoy home theater.
AV amplier
(ZONE2)
AV amplier
(ZONE4)
• Connect the monitor for ZONE2 the same as the “ZONE2 or ZONE3 Pre-out Connectors” (vSee left
column).
• If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2
optical output connectors.
Connections