Filter
Top Products
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting SpecificationsSetup
b If the access points are not detected automatically, use the i
button to select the “Manual” and press the ENTER button.
Setting becomes manual. For details, see “Manual settings”
(vpage 37).
b If the access points are repeat search, use the i button to select
the “Search” and press the ENTER button.
e If there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.)
1
Fitting a rod antenna (vpage 21).
b If a LAN cable is connected, remove it.
2
Turn on the AVP-A1HDCI (vpage 58).
3
Set the access point at the GUI menu “Manual Setup”
– “Network Setup” – “Network Setup”.
When searching access points to connect automatically, refer to
“Automatic settings”.
When searching access points to connect manually, refer to
“Manual settings”.
n Automatic settings
q Select “Search” and press the ENTER button.
The access point you have set is displayed.
w Use the ui button to select the access point, and then press
the ENTER button.
Select when searching
access points again.
Wireless LAN settings
Use this procedure to configure the Wireless LAN settings.
w Select the access point.
Example) DENON
Select when access
points cannot be searched
automatically.
q Select “Search”.
r Set only during
“WEP” in step w.
t Select “Connection”.
e Enter
encryption key.
Use the uio p button to input the “Key” (encryption key) and
press the ENTER button.
Enter the same encryption key as used for the access point.
[Characters that can be input]
A ~ Z
a ~ z
0 ~ 9
! “ # % & ’ ( ) * + , - . / : ; < = > ? @ [ \ ] (space)
When no security settings have been used in the Internet
connection settings, this step is not necessary.
r When encryption is by “WEP”, select the “Default Key” using
the i button, and then press the o p button.
[Selectable items]
1
2
3
4
Select the same default key as used for the access point. This
should normally be set to “1”.
t Use the i button to select “Connection” and press the ENTER
button.
Network connection starts.
When connection is established with the access point,
“Connection completed.” is displayed.
AVP-A1HDCI performs automatic network setup due to the DHCP
function.
When connecting to a network that has no DHCP function,
perform the setting in step 4.