Filter
Top Products
61
HBX Mode:
• Stands for high battery transfer
• Is used with grid-connected FX Series Inverter/Chargers that have utility power as their AC
input
• Is a mode primarily used in applications that have enough renewable energy (RE) power
production to meet the needs of the loads most of the time
• Allows the FX to connect to an AC source if the battery voltage has fallen below a program-
mable set point for a user congurable amount of time (MATE will then allow the FX to
remain connected to the AC source until the battery voltage has risen above a second set
point for a programmable amount of time)
e MATE detects when the battery is truly low and needs charging as opposed to a sudden
and momentary drop caused by a sizable demand for power from a device such as a motor.
At these times, the MATE directs the FX to use AC power until the battery is fully charged
again. e user programs in the amount of time a battery can be below the low voltage and
the amount of time aer it’s fully charged before the MATE starts issuing its commands. e
MATE uses these times to switch back and forth between AC and battery power. Additionally,
in HBX mode, the FX charging function can be shut o to allow the alternative energy source
to recharge the batteries while the loads are powered by the utility grid.
MAIN-----------------------------------
8:25:04A
SUM STATUS SETUP ADV
ADV/PASSWORD---------------
enter the password
132
ENTER INC DEC EXIT
ADV/SETTINGS/WARNING
changes made could
adversely affect
system performance
ADV----------------------------------
choose a product:
FX CC DC MATE
ADV/MATE/HBX-------------------
hbx-use 24.0 vdc
griduse point
DOWN ADV INC DEC
ADV/MATE/PG1--------------------
choose category
HBX GRIDUSE AGS PG2
Press <INC> until 141, then press enter
ADV/MATE/HBX --------------------
hbx-use 01.0 hrs
grid delay
DOWN UP INC DEC
ADV/MATE/HBX -------------------
Hbx-drop 01.0 hrs
grid delay
DOWN UP INC DEC
ADV/MATE/HBX --------------------
hbx-drop 26.0 vdc
grid set point
DOWN UP INC DEC
ADV/MATE/HBX ---------------------
end of HBX menu
UP TOP ADV
Press <INC> and <DEC> so keys as
needed to change set points