Filter
Top Products
55
NOTE : EQ (EQUALIZE) is not an automatic
part of the FX’s charge cycle. With the AC input
already connected to the FX system, an EQ charge
must be manually started from this menu. e
EQ cycle ends aer the time it takes to charge the
batteries to the EQ voltage and the EQ time limit
or by manually stopping the EQ charge from this
menu.
Pressing <EQ> on the CHARGER MODE
CONTROL screen brings up the EQUALIZE
CONTROL screen
When <STOP> has been selected, the EQ charge
has stopped.
When <START> has been selected, two
informational screens are displayed. e user
must push the <MORE> so key before an
equalizing cycle can begin.
EQUALIZE CONTROL
eq enabled
START STOP OK
NOTE: Start the generator or check that the grid
is connected before starting an EQ cycle. e AC
IN status LED on the FX must be solid yellow.
e EQ ENABLED screen allows an equalize
charging cycle or an exit. Press the <YES> so key
to enable and then press <EXIT>.
EQ parameters must be set in
ADV/FX menu. follow mauf.
Recommendations
MORE
For EQ settings ac source must be
connected to start EQ cycle
MORE
EQ ENABLED: No
are you sure you wish to start an
EQ cycle?
YES EXIT
EQUALIZE CONTROL
eq charge stopped
OK MAIN