Filter
Top Products
6.
OPERATIONS
Note:
•
Be
sure
to
read this
chapter
referring to the front diagrams
of
chapter "3. CONTROLS" on
page
6.
Basic Operations
Be
sure
to
lower
the
volume
before
switching
off
the
unit
power
or
the
ignition
key.
The
unit
remembers
its
last
volume
setting.
If
you
switch
the
power
off
with
the
volume
up,
when
you
switch
the
power
back
on,
the
sudden
loud
volume
may
hurt
your
hearing
and
damage
the
unit.
Turning
on/off
the
power
Note:
• Be careful about using this unit for
a long time
without running the engine. If you drain the car's
battery too
far,
you
may
not
be
able to start the
engine
and
this can reduce the service life
of
the
battery.
1. Press the [SAC] button.
2.
The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3.
Press and hold the [SAC] button for 1
second
or
longer to turn off the power for the
unit.
Note:
• System
check
The
first time this unit is turned on after the wire
connections are completed, it must be
checked
what equipment is connected. When the
power
is turned on, the "S-CHECK" appears in the
display, then the unit returns to the
clock
display
mode.
The
system
check
starts within the unit.
Then press the {SRCj button again, the unit turn
to the radio mode.
Selecting a
mode
1. Press the [SAC] button to change the
operation mode.
2. Each time you press the [SAC] button, the
operation mode changes
in
the following
order:
Radio'"
(Satellite radio)
CD/MP3/wMA/
AAC
...
USB/MTP/iPod (CD changer)
...
(DVD changer)
...
(TV) AUX
...
Radio .
* External equipment not connected with
CeNET
is
not displayed.
* iPod/MTP
can
connect to this unit via USB
SLOT.
Adjusting
the volume
1.
Turning the
[AOTAAY]
knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
*
The
volume level
is
from 0 (minimum)
to
33
(maximum).
Switching
the display
Press the [DISP] button to select the desired
display.
* Once selected, the preferred display becomes the
display default. When a function adjustment such
as
volume
is
made, the screen will momentarily
switch
to
that function's display, then revert back
to
the preferred display several seconds after the
adjustment.
*
If
the button operation
is
performed with the
screen saver function
on,
the operation display
corresponding
to
the button operation
is
shown
for about 30 seconds
and
the display returns
to
the screen saver display.
For details, refer
to
the subsection "Turning the
screen saver function on
or
off'
in
section
"Operations Common
to
Each Mode".
DXZ385USB 13