Filter
Top Products
EFFECT
22
DIVIDER
Within the eect chain, the point where the signal is split into channels
“A” and “B” is called the “divider,” and the point where the two signals are
recombined is called the “mixer.”
You can use the divider to switch between channels “A” and “B,” to assign
strongly picked notes and softly picked notes to dierent channels, or
to assign dierent frequency bands of your guitar sound to dierent
channels.
The mixer lets you adjust the volume balance of channels “A” and “B,”
place them in the stereo eld, or slightly delay the sound of channel “B” to
produce a spacious sound.
DIVIDER MIXER
Parameter Value Explanation
MODE
SINGLE Use only one channel, either “A” or “B.”
DUAL Use the two channels “A” and “B.”
SINGLE
Parameter Value Explanation
CH SELECT Ch. A, Ch. B Selects the channel to use.
DUAL Ch. A, DUAL Ch. B
Parameter Value Explanation
Ch. A/Ch. B
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+
Only notes picked more strongly than the
DYNAMIC SENS setting will be output.
POLAR-
Only notes picked more softly than the
DYNAMIC SENS setting will be output.
Ch. A/Ch. B
DYNAMIC
SENS
0–100 Species the picking sensitivity.
Ch. A/Ch. B
FILTER
OFF The lter will not be used.
LPF
Only the region below the cuto frequency
will be output.
HPF
Only the region above the cuto frequency
will be output.
Ch. A/Ch. B
CUTOFF FREQ
100 Hz–2 kHz Cuto frequency
MIXER
Parameter Value Explanation
MODE
STEREO
Channels “A” and “B” will be mixed and output
in stereo.
PAN L/R
Channels “A” and “B” will be assigned
respectively to the L and R OUTPUT jacks.
CH A/B
BALANC
100:0–0:100
Adjusts the volume balance of channels “A”
and “B.”
* This is shown only if DIVIDER MODE is set
to “DUAL.”
SPREAD 0–100
Slightly delays the sound of channel “B” to
make the sound more spacious.
* This is shown only if DIVIDER MODE is set
to “DUAL.”