Filter
Top Products
PAGE
29
Community XLT / XLTE Series Owner’s Manual
8 ACOUSTICAL ADJUSTMENTS
Once the loudspeaker has been connected according to your configuration, it is ready for acoustical adjustments.
This is normally a one-time procedure. Once set, you should not need to change these adjustments. However,
when using a system in different environments or for different types of programs you may want to change some
adjustments as needed to maximize sound quality.
8.1 INITIAL TESTING
The following procedures are designed to prevent damage to the loudspeaker during initial testing of the system.
1. Before powering up any equipment, turn down the input volume controls on the power amplifier and set other
volume controls in the system to their normal operating positions. If you don’t know what those positions are,
setting sliders about half-way up and rotary controls to their 12 o’clock or half-way position is usually a safe bet.
2. Turn on all the electronics for the system in signal chain order starting with the input equipment and continuing in
order through the chain turning on the power amplifiers last. This avoids electronic start-up transients or spikes that
some equipment generates. These spikes can cause instantaneous and permanent damage to the loudspeakers. This
procedure should be followed EVERY TIME the system is turned on.
NOTE:
When turning off a system, do it in the reverse order, beginning with the power amplifiers first.
3. Apply an input signal to the system. This could be a test signal or program material from a tape, CD, or tuner.
Using equipment signal level indicators, a voltmeter, and/or a test headset verify that the signal chain is operating
properly up to the input of the power amplifier. You may have to re-adjust controls as set in step 2 to get a normal
signal level through to the amplifier input(s).
4. If the signal chain tests OK, slowly turn up the input volume control on the amplifier(s) and you should hear the
input signal reproduced through the loudspeaker. It should be clean and clear. If using BIAMP mode and/or
subwoofers, the sound may not be balanced between the high and low frequencies. You will correct this when
making the final adjustments (see SECTION 8.2.3).
5. If all is well, you are ready for the final adjustments to the system.
8.2 FINAL ADJUSTMENTS
There are two primary things to consider when making final adjustments on a system: electronic gain structure and
loudspeaker volume level balancing. The gain structure of a system will determine the dynamic range of a system or
the ratio of the softest to loudest usable sounds. The softest sounds will be limited by the amount of system noise
and the loudest sounds by noticeable distortion or clipping. Loudspeaker volume level balancing includes primarily
those systems where a subwoofer is used and/or a full-range loudspeaker is used in BIAMP mode. It also includes
permanent installations where different models and multiple loudspeakers, such as delayed units, are used.
8.2.1 Electronic Gain Structure
Detailed instructions on how to set electronic gain structure are beyond the scope of this manual. However, the
following general guidelines may be helpful.
1. The preferable tool is an oscilloscope that can be used to observe the signal directly. You can use a voltmeter if
you know the maximum voltage output specifications. If neither of these is available, you can use clipping indicators
on each piece of equipment in the signal chain. As a last resort, you could use high impedance earphones (600
Ohms or higher) or a piezo-electric tweeter and listen for noticeable distortion at the output of each piece of
equipment. This point will be just above the maximum output. Without some method of determining the maximum
output on each piece of equipment, you cannot expect to optimize the gain structure.