Filter
Top Products
PAGE
23
Community XLT / XLTE Series Owner’s Manual
6.4.2 BIAMP Mode Wiring (See FIGURE 5)
Installing and operating loudspeakers in BIAMP mode requires putting the slide switch on the input panel in the
BIAMP (up) position. In this mode the LF and HF connections must be made using either of the Neutrik Speakon
jacks. Note that each Speakon jack can accept both the LF and HF inputs. The 1/4 in. jacks are not used for BIAMP
mode. Observe proper polarity when making the connections.
6.4.3 Subwoofers (See FIGURE 6)
The wiring connections for the subwoofers are the same whether it is used in a stand-alone fashion or configured
with a full-range loudspeaker that is used in either PASSIVE or BIAMP mode. Observe that when the FULL-RANGE
OUTPUT on the subwoofer is used with a full-range loudspeaker in BIAMP mode, the subwoofer FULL-RANGE
OUTPUT is connected to the LF input on the full-range loudspeaker. For convenience, the 1/4 in. jack may be used
for this connection. (See “Technical Note” in SECTION 6.2.2). Observe proper polarity when making connections.
FIGURE 5: Wiring for BIAMP Mode Full-Range
FIGURE 6: Wiring for Subwoofer