Filter
Top Products
Section 4–Device Discovery and Addressing ATC200-Lite Teletilt
®
Remote Control Downtilt System
4-2 May 2005 Bulletin 639510
2. The ‘Auto Discovery’ bar (located at the top of the screen) and the Command Status/Re-
sponse window (located at the bottom of the screen) will show the status on the search’s
progress (Figure 4-2). As each device is found during the search, the Command Status/
Response window will show the status of how many devices have been found .
NOTE: The amount of time the device search takes is dependent upon the number of AISG
devices present on the tower. Typically, search on a tower that contains a small number of
devices, such as 6, will take about 3 minutes. A search on a tower with a full compliment
of devices may take up to 10 minutes.
The ‘Cancel Search’ button can be used to halt the device search at anytime. Note that
if a device search is halted, a new search can be started. To start a new device search,
click on the ‘Find Devices’ button again (Figure 4-2).
Figure 4-2. Progress Shown During Device Search.
Device search in progress.
Can take up to 10 minutes to
complete, depending on # of
devices.
Device search progress shown in Command Status/Response window.
Click ‘OK’.
Figure 4-3. Device Search Results.