Filter
Top Products
Section 3–Program Startup and Conguration ATC200-Lite Teletilt
®
Remote Control Downtilt System
3-4 May 2005 Bulletin 639510
3.3 Beginning Program Operation
After program startup and serial port selection, note the text displayed at the bottom
of the screen in the ‘Command Status/Response’ window (Figure 3-3). This window is
used to display the current status of the program, the progress of various commands
that have been initiated by the user, and the nal results of commands, such as success
or failure messages.
3.4 Antenna Definition File Selection
A single antenna denition le is placed in the ‘C:\Program Files\Andrew Corporation\ATC200
Lite’ directory of the PC during program installation. This le is automatically searched for
and loaded during program startup.
The antenna denition le provides a list of all the Andrew base station antennas compatible
with the ATC200-Lite control system. The program automatically selects and uses the latest
version antenna denition le. If a different antenna denition le is desired for use, place
the desired antenna denition le in the ‘C:\Program Files\Andrew Corporation\ ATC200 Lite’
directory and restart the program to make it available for selection. Note that the program only
recognizes antenna denition les that were present in the directory noted above at the time
of program startup. If a new le is placed in this directory, the program must be restarted for
the new le to be recognized and visible in the drop down list shown in Figure 3-9.
1. To select a different antenna denition le, go to ‘Tools, Antenna Files . . .’ from the main
menu at the top of the screen (Figures 3-8).
2. Click on the drop down list arrow to select the desired antenna denition le from
the list (Figure 3-9).
3. Click ‘Load File’ to load the selected antenna denition le for use (Figure 3-9). Conrmation
that the le was loaded will be displayed in the ‘Command Status/Response’ window.
4. Click ‘Close’ after antenna denition le has been loaded successfully.