Filter
Top Products
67-EN
01GB06DVA9861Ri.fm
ALPINE DVA-9861Ri 68-04123Z62-A (EN)
System Example
Connect the Ai-NET compatible digital audio processor (Fiber optic compatible) and touch panel compatible monitor/changer.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Video output Lead
(Yellow)
Video input terminal
RCA Extension cable (video) (included)
Touch panel
compatible
monitor box
(sold separately)
Touch panel
compatible monitor
(sold separately)
Remote control input Lead
(White/Brown)
Remote control output Lead
(White/Brown)
Monitor control Lead
(White/Pink)
Monitor control Lead
(White/Pink)
To Digital output terminal
Fiber optic Cable
Fiber optic input terminal (for head unit)
Ai-NET Cable
Ai-NET output terminal
Ai-NET compatible digital
audio processor
(sold separately)
(Fiber optic compatible)
Ai-NET Cable
Fiber optic input
terminal
(for changer)
*
Fiber optic
cable
Ai-NET compatible CD
changer (sold separately)
System switch EQ/DIV
Only connect fiber
optic compatible
CD changer
• When the fiber optic compatible product is connected, it is necessary to set
the mode of this unit. Refer to “Setting the Digital Output” (page 30) and set
to ON.
Please observe the following when using Fiber Optic Cable.
• Be careful not to bend the fiber optic cable at a sharp angle.
• Do not coil the fiber optic cable smaller than a 30 mm radius.
• Do not place anything on top of the fiber optic cable.
*
01GB00DVA9861Ri.book Page 67 Wednesday, December 7, 2005 12:00 PM