Filter
Top Products
10-EN
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time,
after changing the car battery, etc.
1
Turn off the unit power.
2
Press y (OPEN) to open the front panel, and then remove
it.
3
Press RESET with a ballpoint pen or similar pointed object.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level
by 20 dB.
1
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
2
Pressing MUTE again will bring the audio back to its
previous level.
Setting the Time and Calendar
1
Press and hold AUDIO/SETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select the General mode, and
then press ENTER.
3
Turn the Rotary encoder to select Clock Adjust, and then
press ENTER.
4
Turn the Rotary encoder to set year.
5
Press ENTER.
6
Repeat steps 4 and 5 above to set month, date, hour and
minute.
7
Press and hold AUDIO/SETUP for at least 2 seconds to
return to normal mode.
Notes
• Pressing r returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is canceled.
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold ENTER for at least 2 seconds after
setting the “hour”. Minutes will reset to 00. If the display shows over
“30” minutes when you do this, the time will advance one hour.
RESET switch
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
Connectable to Remote Control Interface Box
With an optional Alpine Steering Wheel Remote Control Interface
Box, this unit is controllable from the vehicles steering wheel
controls. For details, contact your Alpine dealer.
Remote control sensor