Filter
Top Products
SERVICING NOTICES ON CHECKING
1. KEEP THE NOTICES
As for the places which need special attentions, they are
indicated with the labels or seals on the cabinet, chassis
and parts. Make sure to keep the indications and notices
in the operation manual.
2. USE THE DESIGNATED PARTS
The parts in this equipment have the specific
characters of incombustibility and withstand voltage for
safety. Therefore, the part which is replaced should be
used the part which has the same character.
Especially as to the important parts for safety which is
indicated in the circuit diagram or the table of parts as
a mark, the designated parts must be used.
3. PUT PARTS AND WIRES IN THE ORIGINAL
POSITION AFTER ASSEMBLING OR WIRING
There are parts which use the insulation material such
as a tube or tape for safety, or which are assembled in
the condition that these do not contact with the printed
board. The inside wiring is designed not to get closer to
the pyrogenic parts and high voltage parts. Therefore,
put these parts in the original positions.
PERFORM A SAFETY CHECK AFTER
SERVICING
4.
Confirm that the screws, parts and wiring which were
removed in order to service are put in the original
positions, or whether there are the portions which are
deteriorated around the serviced places serviced or not.
Check the insulation between the antenna terminal or
external metal and the AC cord plug blades. And be sure
the safety of that.
IMPORTANT NOTICE
The remote control for this model can be selected the Custom code 1 and Custom code 2.
• How to selection;
Custom code 1 : P
Custom code 2 :
Press the Power key and 1 key on the remote control
simultaneously for more than 2 seconds.
Press the Power key and 2 key on the remote control
simultaneously for more than 2 seconds.
The Custom code 1 is only available for the VCR unit but the Custom code 2.
When selected the Custom code 2 by mistake, just remove the batteries from the remote
control for the moment or select the Custom code 1 as described above.
A-2