Filter
Top Products
,
~
CONNECTING OPTIONAL
LISTENING TO EXTERNAL
1
EQUIPMENT
SOURCES
!
~
I “Fr I 8“’’:AtT0uT1
POWER
ml ‘“”–
— SUPtH
WOOFER
~
To play equipment connected to the VIDEO/AUX jacks or MD
Refer to the operating instructions of the connected equipment
jacks, proceed as follows.
for details.
● The connecting cords are not supplied. Obtain the necessary
1 Press the VIDEO/AUX or MD button.
connecting cords.
When a equipment connected to the VIDEO/AUX jacks is
● Consult your local Aiwa dealer for optional equipment.
played: press the VIDEO/AUX button.
VIDEO/AUX, MD JACKS
When a equipment connected to the MD jacks is played:
press the MD button.
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
2’ Play the connected equipment.
(turntables, LD players, MD players, VCRS, TV, etc.).
Connect the red plug to the R jack, and the white plug to the L
To change a source name in the display
I
When the VIDEO/AUX button is pressed, VIDEO is displayed
jack.
initially. It can’be changed to’AUX or TV.
When connecting a turntable
With the power on, press the POWER button while pressing the
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
VIDEO/AUX button.
Repeat the procedure to select one of the names.
LINE OUT JACKS
This unit can output analog sound signal through these jacks.
To adjust the sound level of the external source
Use a cable with RCA phono plugs to connect audio equipment
When the sound level of the external source is much higher or
with LINE IN (analog input) jacks.
much lower than that of other function sources, adjust it as ‘
follows. ~
m
1 Press the VIDEO/AUX or MD button and play the equipment.
Do not connect an equipment to the LINE OUT terminals and
2 Presss the++ or
➤> button so that the sound level becomes
VI DEO/AUX terminals simultaneously. Otherwise, noise is
the same as that of other function sources.
generated and malfunction occurs.
CD DIGITAL OUT (OPTICAL) JACK
m
During recording, the sound level can not be adjusted. .
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
.,
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack-
—
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
\
Attach the supplied dust cap.
SUPER WOOFER 4 JACK
Connect an optional powered sub woofer with a built-in-amplifier
to the jack.
23 ENGLISH
,.
.