Filter
Top Products
Al EDIT RECORDING
6 Press the ● REC/REC MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press the
■ button. Recording and CD play stop simultaneously.
To clear the edit program
,
Press the
■ CLEAR button twice so that “EDIT” disappears on
the display.
To check the order of the programmed track numbers
Before recording, press the CD EDIT/CHECK to select side A or
B, and press the + or - button repeatedly.
Programmed
Track number track numbers
I
m
Program number
Al edit recordina will not start from a ~aint halfwav into the ta~e.
To add tracks from other discs to the edit program
The tape must ;e recorded from the’beginning o; either side.
If there is any time remaining on the tape after step 5, you-can
add tracks from other discs in the CD compartment.
1
2
3
Insert the tape into deck 2, and press the DOLBY
1
Press the CD EDIT/CHECK button to select side A or B.
NR button to turn Dolby NR on or off.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
Insert the tape with the side to be recorded on first facing out
3 Press the numbered buttons on the remote control to select
from the unit.
tracks. PRGM appears on the display.
A track whose playing time is longer than the remaining time
Press the CD button and load the disc(s).
cannot be programmed.
Press the CD EDIT/CHECK button once.
4 Repeat steps 2 and 3 to add more tracks.
“EDIT” and “Al” Jight up on the display.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer-than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
Each time it is”pressed, the display changes as follows.
Al EDIT — PRGM EDIT
m
● Recordina is inhibited if the erasure ~revention tab on either
4
5
Press one of the DISC DIRECT PLAY buttons to
side of th; tape is broken off. ‘
select a disc.
● The Al edit function cannot be used with discs containing 31
tracks or more.
Press the < or W button to designate the tape
length.
10
to 99 minutes can be specified.
In a few seconds, the microcomputer dete~mines the tracks
ta be recorded on each side of the tape.
● The numbered buttons on the remote control are also
available to designate the tape length.
Example: When using a 60-minute tape, press the 6 and O
buttons.
Tape side A Selected
Tape length
(front side)
tracks for side A