AEG IR 4427 Radio User Manual


 
8
16 (SNOOZE): When alarm is sounding, snooze for a set time.
17 INFO: Press to view more information about the station or track playing. Press again to cycle through
further information screens then return to the normal Now playing screen.
18 STANDBY: Turn on or back to standby mode (showing clock and date). Cancels sleep function.
19 ALARM: Press to enter alarm setting menu.
Insta
InstaInsta
Install the remote control batter
ll the remote control batterll the remote control batter
ll the remote control battery
yy
y
1. Remove the battery cover.
2. Insert the battery of the type CR 2025 into the battery compartment. Make sure that the + symbol faces
upwards.
3. Replace the cover.
WARNING
WARNINGWARNING
WARNING:
Leaking out battery acid can damage your health. Remove the battery from the battery compartment as
soon as it is exhausted or if the remote control is not going to be used for a longer period of time. Wipe up
leaked out battery acid with a cloth. In case of skin contact immediately wash the affected area. Seek
medical advice if battery acid has been swallowed. In case of contact with your eyes wash out the eyes
and seek medical advice.
Do not expose the battery to high temperatures or direct sunlight. Never throw batteries into the fire.
There is a danger of explosion
danger of explosiondanger of explosion
danger of explosion!
Never try to recharge batteries, short-circuit, cutting or buried.
Avoid contact with metallic objects (Rings, nails, screws et cetera). There is a danger of short
shortshort
short-
--
-circuiting
circuitingcircuiting
circuiting!
As a result of a short-circuit batteries may heat up considerably or even catch fire. This may result in
burns.
CAUTION:
CAUTION:CAUTION:
CAUTION:
Batteries are not to be disposed of together with domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer’ s.
Improper installation of batteries can cause leaking out and corrosion and leaving the remote irreparable
damaged.
NOTE:
NOTE:NOTE:
NOTE:
If the remote control is not going to be used for an extended period of time, remove the battery.
Exhausted batteries should be replaced immediately to prevent corrosion damage.
If the range of the remote control is reduced replace the cell by a battery of the same type (CR 2025).
Usage of the remote control
Usage of the remote controlUsage of the remote control
Usage of the remote control
Align the remote control directly at the remote control sensor of the device.
The range of the remote control depends on the brightness of the room and the charge of the battery.
Bright light (Sun or artificial light) should not fall directly at the remote control sensor. Bright light can
negative influence the efficacy of the remote control.
Make sure that they be no obstacles between the remote control and the remote control sensor.