Filter
Top Products
15
© 3M 2011. All Rights Reserved.
3M™ Digital Projector X56
Connecting to a power supply
1.
Insert the connector of the power cord into
the AC IN (AC inlet) of the projector.
2.
Firmly plug the power cord into the outlet.
Wait a few seconds and the POWER
indicator will light up in steady orange.
►Please use extra caution when connecting the power cord, as
incorrect or faulty connections may result in re and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Never modify the power cord.
WARNING
Using the security bar and slot
AC IN
Power
cord
A commercially available anti-theft chain or
wire can be attached to the security bar on
the projector. Refer to the gure to choose
an anti-theft chain or wire.
Also this product has the security slot for the
Kensington lock.
For details, see the manual of the security
tool.
►Do not use the security bar and slot to prevent the projector
from falling down, since it is not designed for it.
►Do not place anti-theft chain or wire near the exhaust vents.
It may become too hot.
CAUTION
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
NOTE
Security slot
Anti-theft chain or wire
Please remember that when the DIRECT POWER
ON function is activated (
54), connecting the
power supply will turn the projector ON.
Setting up
security bar