Filter
Top Products
21
© 3M 2011. All Rights Reserved.
3M™ Digital Projector X56
Operating
Selecting an aspect ratio
● ASPECT button does not work when a signal is not detected.
● NORMAL mode keeps the original aspect ratio setting.
1.
Press SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to nd any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
Searching an input signal
● While ON is selected for AUTO SEARCH item in OPTION menu (54), the
projector will keep checking the ports in above order repeatedly till an input
signal is detected.
●
It may take several seconds to project the images from the USB TYPE B port.
For a computer signal
For a video signal, s-video signal or component video signal
For an input signal from the LAN, USB TYPE A or USB
TYPE B port, or if there is no signal
4:3 (xed)
SEARCH button
PAGE UP
PAGE
DOWN
VIDEO
MY SOURCE/
DOC.CAMERA
STANDBY/ON
FREEZE
MAGNIFY
ASPECT SEARCHAUTO
BLANK
MUTE
VOLUME
KEYSTONE
MY BUTTON
POSITION
ESC
ENTER
MENU
RESET
COMPUTER
1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
ASPECT button
PAGE UP
PAGE
DOWN
VIDEO
MY SOURCE/
DOC.CAMERA
STANDBY/ON
FREEZE
MAGNIFY
ASPECT SEARCHAUTO
BLANK
MUTE
VOLUME
KEYSTONE
MY BUTTON
POSITION
ESC
ENTER
MENU
RESET
COMPUTER
COMPUTER IN1 COMPUTER IN2 LAN
VIDEO USB TYPE A
S-VIDEO USB TYPE B
COMPONENT
HDMI
For an HDMI
TM
signal