Filter
Top Products
22
© 3M 2011. All Rights Reserved.
3M™ Digital Projector X56
Operating
Adjusting the projector’s elevator feet
If the projector is set on a slightly uneven surface to the
left or right, use the elevator feet to adjust the horizontal
position.
Using the feet can also tilt the projector in order to
project at a suitable angle to the screen, elevating the
front side of the projector within 12 degrees.
This projector has 2 elevator feet and 2 elevator buttons.
An elevator foot is adjustable while pushing the elevator
button on the same side as it.
To loose an
elevator foot, push
the elevator button
on the same side
as it.
To nely
adjust, twist
the foot.
1.
Holding the projector, push the elevator buttons to
release the elevator feet.
2.
Position the front side of the projector to the desired
height.
3.
Release the elevator buttons in order to lock the
elevator feet.
4.
After making sure that the elevator feet are locked,
put the projector down gently.
5.
If necessary, the elevator feet can be manually
twisted to make more precise adjustments. Hold the
projector when twisting the feet.
►Do not handle the elevator buttons without holding the
projector, since the projector may drop down.
►Do not tilt the projector other than elevating its front within 12 degrees using
the adjuster feet. Exceeding the projector’s tilt restriction could shorten the lamp
life and/or cause the projector to malfunction.
CAUTION