62
TROUBLESHOOTING
Section C
Remove the misfed original from the exit area.
If the original cannot be easily removed from the
exit area, open the moveable part of the
document feeder tray and remove the original. If
an RSPF is installed, remove the reversing tray
and then remove the original.
2
Open and close the SPF/RSPF to
make the misfeed indicator stop
blinking.
You can also make the
misfeed indicator stop
blinking by opening and
closing the feeding roller
cover or the document
conveyor cover.
3
Return the originals indicated by the
minus number in the display to the
document feeder tray and press the
[START] key ( ).
Copying will resume from the originals that still
remained when the misfeed occurred.
When an original is misfed in the SPF/RSPF, a
number will appear in the display with a minus
sign.
The number indicates the number of original
pages that were not scanned correctly. After
removing the misfeed, return the indicated
number of original pages to the SPF/RSPF and
resume copying.
MISFEED IN THE BYPASS TRAY
1
Pull the misfed paper out.
2
Lift the side cover slightly and slide it
out until it stops. Close the side cover
by pressing down on the handle on
the cover.
The misfeed indicator
( ) stops blinking and
copying can be resumed.
After removing a misfed original from the exit
area, be sure to attach the reversing tray
securely to the exit area (when the RSPF is
installed).
Note
• When closing the side cover, press down
on the handle.
• If the misfeed indicator ( ) does not stop
blinking, check for torn pieces of paper in
the machine.
Note
