the “Vehicle Remote Mount Antenna Installation Sheet” for details.
Internal Antenna
If the internal antenna option is ordered, an antenna is mounted on the inside of the user
access panel cover.
The internal antenna assembly has two antenna cables. Attach the antenna cables to the
radio card. When this process is complete, reattach the access cover screws using a torque
wrench capable of measuring to 9±1 inch pounds force (1.016±.11 N m). The screws must be
fastened to 9 inch pounds each. The screws require a Phillips size 1 driver head.
Connect Serial Barcode Scanner
Refer to the documentation received with the barcode scanner for complete instructions. Read
all warnings and caution labels.
Before using the scanner, read section titled “Operation”, sub- section titled “Laser Barcode
Scanner Warnings”.
Pin 9 of COM1 is configured to provide +5V. To change Pin 9 of the port, please refer to
Chapter 4, “System Configuration” in the “VX7 Reference Guide”.
The scanner cable is attached to the connector labeled “COM1/SCANNER”. The scanner
receives power from the VX7.
The cable requires a nine-pin D-shell female connector for the VX7.
Note: Use of a shielded cable is required to maintain FCC and CISPR22 emissions
compliance.
1. Power off the VX7 before connecting the scanner cable to the VX7.
2. Seat the connector firmly over the pins and turn the thumbscrews in a clockwise direction. Do
not overtighten.
3. Use a strain relief clamp to secure the cable.
4. Press the power button to power up the VX7.
When you have finished using the scanner, remove it from the VX7 and store the scanner in a
