Install Stylus Tether and Sleeve
The LXE stylus kit includes the stylus, tether and sleeves. The tether allows the stylus to be
mounted to the VX7 and the sleeve provides storage for the stylus when not in use.
How To Install Stylus Tether and Sleeves
Locate the tether holes on the top of the VX7. (see below):
Select the mounting hole most convenient for the particular VX7 installation.
Slide the clip end of the stylus tether into the tether mounting hole.
Determine a convenient location for the stylus sleeve. Apply the adhesive baked Velcro
®
loop
strip to the VX7 or mounting bracket. Attach the Velcro
®
hook strip on the elastic stylus
sleeve to the loop strip.
Install/Remove Touchscreen Protective Film
LXE offers a replaceable touchscreen protective film to protect the touchscreen when the VX7
is used in an abrasive environment.
How To Install Touchscreen Protective Film
Make sure both the touchscreen and protective film are clean and dry before installation.
Please review “Cleaning the Display”, later in this guide, for instructions on suitable cleaning
agents.
Center the protective film over the touchscreen. The antiglare side must be facing outward.
Do not cut or trim the protective film.
The protective film is approximately 1/10” (2.54cm) larger than the touchscreen at the centers
of the edged (indicated by the arrows in the figure above).
Slide the protective film so that one of the edges of the film can be slid between the
touchscreen and display housing when the protective film is re-centered on the touchscreen.
Repeat for the other three edges, ensuring the protective film is centered over the
touchscreen when finished.
How to Remove Touchscreen Protective Film