Procedure
Step 1 - Mount Bottom Mounting Bracket To Vehicle.
1. Position the bracket to allow access to the switches and ports on the bottom of the VX7.
2. Attach the bottom mounting bracket to the vehicle mounting surface using a minimum of four
1/4 bolts (or equivalent) fasteners.
Note:1/4 Bolts and washers not included. It is recommended to use lock washers and flat
washers on the fasteners.
IMPORTANT: Mount to the most rigid surface available.
After the bottom bracket has been attached to a rigid surface, you are ready to assemble the
VX7 bracket configuration.
Step 2 – Attach Rear Bracket VX7
1. Turn the VX7 off before attaching the rear bracket.
2. Place the VX7 face down on a stable surface.
3.
Align the rear bracket with the holes on the back of the VX7. Attach with four 1/4-
20x5/8 bolts, using one flat washer and one locking washer per bolt. Place the
locking washer on the bolt before the flat washer.
Step 3 – Attach VX7 Assembly To Bottom Mounting Bracket.
1. Place lock washer first, then flat washer on 1/4-20x5/8 bolt. Next insert mounting bolts
through the curved apertures in the bottom mounting bracket and into the screw holes on the
side of the back mounting bracket.
2. Loosely tighten each bolt as it is inserted.
Important: Do not torque bolts until all bolts are in place and viewing angle is
adjusted.
3. Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX7.
4. Torque the hex bolts to 50±5 in/lb (5.64±.56 N/m).
Note: Test the torque on the bolts frequently during operation and re-tighten if
necessary to 50±5 in/lb (5.64±.56 N/m).
