To remove the protective film, slide the protective film in one direction until the edge clears.
Lift up on the edge of the film so it does not slide between the touchscreen and display
housing when slid back. Repeat until all edges are free and remove the protective film.
Remote LXE Keyboard Bracket Assembly
Equipment Needed: Phillips screwdriver, torque wrench.
1. Place the keyboard face down on a flat, stable surface.
2. Position the bracket on the keyboard base, aligning the four screw holes in the keyboard
with the four mounting holes in the bracket flanges. When positioned correctly, the bracket
should overlap at the top of the keyboard.
3. Attach the keyboard to the bracket with four screws (included). Tighten to 9 +/- 1 in/lb (1.02
N/m).
4. Attach the keyboard-bracket assembly to the vehicle’s mounting surface using four 1/4 bolts,
lock washers and flat washers or equivalent.
Note: Bolts, washers, and wrench needed when attaching the bracket to the vehicle are not
supplied by LXE.
IMPORTANT: Mount to the most rigid surface available.
Remote Keyboard Mounting Dimensions
The overall space required for the keyboards are:
•
LXE 95-key keyboard: 5.75” (146.05mm) x 13.40” (340.40mm)
•
LXE 60-key keyboard: 4.40” (111.50mm) x 11.90” (302.00mm)
