
ENWW Stacker section 47
Finisher unit explanation
of the first set, and a predefined time
period has elapsed, M713 (stacker
entrance) stops. This action ensures
that the stapling of the first set
completes before the sheets of the
second set are fed to the stacker
section (the first sheet waits on the
bypass channel).
3 Second sheets of the second and
subsequent sets
When PS704 (finisher entrance) has
detected the trailing edge of the
second sheet of the second (and
subsequent sets), and a predefined
time period has elapsed, M713
(stacker entrance) rotates as a high
speed. This action allows the first and
second sheets to be conveyed to the
stacker section at the same time.
4 Third and subsequent sheets of the
second and subsequent sets
The third and subsequent sheets of
the second (and subsequent sets) are
conveyed to the stacker in the same
manner as the sheets of the first set.
c Folding and stitch-and-folding modes
The finisher operation signal from the
MFP lets M713 (stacker entrance) start
to rotate at a high-speed.
When PS705 (stacker entrance) has
detected the rear end of the paper, the
rotation speed of M713 changes to low,
conveying the paper slowly to the
stacker. Then, after a predefined time
has elapsed, the rotation returns to the
high-speed mode to prepare for the next
conveyance of paper.
When the last sheet of the set has been
aligned, M713 stops.
When PS725 (folding paper exit) has
detected the rear end of the set, M713
(stacker entrance) returns to its
high-speed rotation mode to prepare for
the next paper conveyance.
d Tri-folding mode
The finisher operation signal from the
MFP lets M713 (stacker entrance) start
to rotate at a high-speed.
When PS705 (stacker entrance) has
detected the trailing edge of the paper,
the rotation speed of M713 changes to
low, conveying the paper slowly to the
stacker. Then, after a predefined time
has elapsed, the rotation returns to the
high-speed mode to prepare for the next
conveyance of paper.
When the last sheet of the set has been
aligned and the booklet stopper has
moved to the tri-folding position, M713
stops.
When PS729 (folding full) has detected
the trailing edge of the set, M713
(stacker entrance) returns to its
high-speed rotation mode to prepare for
the next paper conveyance.
2 Signals
a Finisher CB output signals
1 M713 CLK (finisher CB to RB)
Signal relating to the clock for
controlling the rotation speed of M713
2 M713 RESET (finisher CB to RB)
Reset signal for M713
3 M713 CONT (finisher CB to RB)
Signal to activate or deactivate M713
[L]: M713 on
[H]: M713 off
b RB output signals
1 M713 DRV A, A
(RB to M713)
Pulse signal to drive/control the
Phase A of M713
2 M713 DRV B, B
(RB to M713)
Pulse signal to drive/control the
Phase B of M713