A SERVICE OF

logo

ENWW Paper feed section 19
HCI disassembly/assembly
Replacing the separation roller
rubber
CAUTION If HCI is connected to the
MFP, make sure that the
MFP power plug is
disconnected from the
power outlet.
Procedure
CAUTION With the power held on,
press the HCI tray down
switch (SW100) to move
the up/down plate down to
the bottom in advance.
1 Remove the pick roller unit.
2 Remove two screws to detach the
separation roller unit cover.
3 Remove two screws to detach the
separation roller unit.
CAUTION When reinstalling the
separation roller unit,
tighten the screws on the
rear side first.
4 Remove two snap rings, fit the shaft into
the D-cut in the fitting, and remove the
separation roller together with the shaft.