Contents
Chapter 4 — Electronic Flow Sensing 57...............
Displaying gas flow rate 58...............................................
Designating gas type 59..................................................
Electronic flow sensor (EFS) calibration 60.................................
Preparation 61.......................................................
Setting the zero calibration value 61...................................
Setting the GAIN calibration value 63..................................
Entering specific ZERO and GAIN values 65............................
Chapter 5 — Signal Output 67........................
Zeroing signal output 68..................................................
Displaying current setpoint 69........................................
Self• setpoint 70......................................................
User•defined setpoint 72..............................................
Signal attenuation 72.....................................................
Displaying current
RANGE 2 ()
/
ATTN 2 ()
setpoints 75..............
Entering / setpoints 76..............................................
Switching off the +1 mV output 76.....................................
Test signal output 77.....................................................
Instrument network (INET) 79............................................
The controller 79.....................................................
An instrument 81.....................................................
Active workspace 82..................................................
HP 5890 INET states 82...............................................
INET operation 83....................................................
Automatic INET reconfiguration 85....................................
INET configuration 85....................................................
Switching between Global and Local 86.................................
INET/HP•ILaddresses 87.............................................
HP•ILloopback test 90...................................................
Warn: and fault: messages 92.............................................
File compatibility with data handling devices 94............................
What are the modes? 94...............................................
What is the proper mode for my data handling device? 94................
How do I know in which mode my GC is configured now? 94..............
How do I change modes? 95............................................
How to convert HP 339X Integrator workfiles from 5890A
to SERIES II mode: 97.............................................
