Yamaha RX-V861 Stereo Receiver User Manual


 
94 En
Advanced setup
Speaker impedance SP IMP.
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8 MIN, 6 MIN
Select “8Ω MIN” to set the speaker impedance to 8 .
Select “6 MIN” to set the speaker impedance to 6 .
*
The Canada model cannot use two separate speaker systems
(A and B) simultaneously when “SP IMP.” is set to “8 MIN”.
User presets PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 104).
Choices: CANCEL, RESET
Select “CANCEL” not to reset any parameters of this
unit.
Select “RESET” to reset the parameters of this unit.
This setting completely resets all the parameters of this unit
including the “SET MENU” parameters.
The initial factory settings are activated next time you turn on
this unit.
Remote control AMP ID REMOTE AMP
Use this feature to set the AMP ID of this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers in the same room separately.
Choices: ID1, ID2
Select “ID1” when the remote control AMP ID code is
set to “00001”.
Select “ID2” when the remote control AMP ID code is
set to “00002”.
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the
remote control.
1 Press
U
CODE SET using a ballpoint pen or
a similar object.
The
V
TRANSMIT indicator on the remote control
flashes twice.
2 Press the numeric buttons (
B
) to enter the
code number “00001” or “00002”.
The
V
TRANSMIT indicator on the remote control
flashes twice, and the AMP ID code is changed.
*1
The remote control setting
*2
The setting of this unit
See page 93 for the operation of the advanced setup.
SP IMP. Speaker Impedance level
8Ω MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 8 or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16 or
higher.
*
Center
The impedance of each
speaker must be 8 or
higher.
Surround
Surround back
6 MIN
Front
If you use one set (A or B),
the impedance of each
speaker must be 4 or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8 or
higher.
Center
The impedance of each
speaker must be 6 or
higher.
Surround
Surround back
Notes
AMP ID
code *1
Function
Remote
control AMP
ID *2
00001
(initial setting)
To operate this unit using
the default code.
ID1
(initial setting)
00002
To operate this unit using
an alternative code.
ID2
TRANSMIT
STANDBY
POWER
POWER
POWER
AV
TV
TRANSMIT
CODE SET
Flashes
TRANSMIT
5678
90
1234
CLASSICAL
LIVE/CLUB
ENTERTAIN MOVIE
STEREO
ENHANCER
STRAIGHT
PURE DIRECT
SUR. DECODE
NIGHT
Flashes