Filter
Top Products
25 En
Connections
PREPARATION
English
1 Make sure this unit is turned off.
Refer to the right column for details.
2 Press and hold
C
TONE CONTROL on the
front panel and then press
B
MASTER ON/
OFF inward to the ON position to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the
D
PROGRAM selector on the
front panel to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8Ω MIN”) appear in the front panel display.
4 Press
C
TONE CONTROL on the front
panel repeatedly to select “6Ω MIN”.
5 Press
B
MASTER ON/OFF on the front
panel to release it outward to the OFF
position to save the new setting and turn off
this unit.
The setting you made is reflected next time you turn on this
unit.
■ Turning on this unit
Press
B
MASTER ON/OFF on the front panel
inward to the ON position to turn on this unit.
When you turns on this unit by pressing
B
MASTER
ON/OFF, the main zone is turned on.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Turning off this unit
Press
B
MASTER ON/OFF on the front panel
again to release it outward to the OFF position to
turn off this unit.
•
A
MAIN ZONE ON/OFF on the front panel as well as
H
POWER and
G
STANDBY on the remote control are
operational only when
B
MASTER ON/OFF is pressed
inward to the ON position.
• Basically, we recommend that you use the standby mode to turn
off this unit.
■ Set the main zone to the standby mode
Press
A
MAIN ZONE ON/OFF
(or
G
STANDBY
)
to set the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
■ Turning on the main zone from the
standby mode
Press
A
MAIN ZONE ON/OFF (or
H
POWER) to
turn on the main zone.
y
• You can also turn on the main zone by pressing
F
SCENE (or
F
SCENE) buttons.
• When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
• These buttons are operational only when
B
MASTER ON/
OFF is pressed inward to the ON position.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
Note
TONE CONTROL
MASTER
ON
OFF
While holding
down
Turning this unit on and off
Notes