Yamaha RX-V861 Stereo Receiver User Manual


 
32 En
Optimizing the speaker setting for your listening room
If an error screen appears
Press
D
k / n / l / h to select “RETRY” or
“EXIT” and then press
D
ENTER.
The following display is an example when “E-9:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
Select “RETRY” to retry the “AUTO SETUP”
procedure.
Select “EXIT” to exit from the “AUTO SETUP”
procedure.
If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
“AUTO:RESULT” display. Check the warning messages
to correct your speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1 Make sure the pointer is pointing at
“WARNING” and then press
D
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2 Press
D
l / h repeatedly to toggle between
the warning displays.
y
For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 102.
When the corresponding warning message is not
applicable to a speaker, “––” is displayed instead.
3 Press
D
ENTER to return to the top
“AUTO:RESULT” display.
Note
AUTO:ERROR
. E-9:USER CANCEL
Don't operate
any function.
>RETRY EXIT
[ ]/[ ]:Select
[ENTER]:Enter
[
[
AUTO:RESULT
RESULT
. WARNING(3)
>SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
SP : 3/4/0.1
DIST: 14.0/17.0ft
LVL : -9.0/+6.5dB
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
FL --
CENTER
PL PR
SL SR
SBL SBR
[ ]/[ ]:Select
[ENTER]:Return
[
[