Filter
Top Products
Chapter 2 - Installing the Yamaha CDR200t Drive
9
Audio output cable
Connect an audio output cable to the AUDIO OUT connector in the
lower left corner of the rear panel.
Make sure that the projection of the connector is facing upward.
DC power cable
Connect a DC power cable to the DC INPUT connector on the lower
right corner of the rear panel.
Make sure that the notch on the connector is facing upward
.
RGL
AUDIO OUT
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
RGL
AUDIO OUT
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V