Filter
Top Products
Chapter 2 - Installing the Yamaha CDR200t Drive
7
♦
Parity setting
Parity ON
(with a jumper)
— Parity Check will be performed.
Normally, use this setting.
Parity OFF
(without a jumper)
— Parity Check will not be performed.
♦
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON
(with a jumper)
— Use this setting if the CDR200t is the last device in the internal
SCSI daisy-chain.
Terminator OFF
(without a jumper)
— Use this setting if devices other than the CDR200t are in the inter-
nal SCSI daisy-chain and the CDR200t is not the last device.
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Parity ON Parity OFF
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Terminator ON Terminator OFF