Filter
Top Products
Chapter 2 - Installing the Yamaha CDR200t Drive
6
♦
SCSI ID settings
The SCSI ID number is used so that the computer will recognize a
connected SCSI device. You can assign 0 through 7 as the SCSI ID
number. Usually, “7” is reserved for the SCSI card ID number, and
“0” is reserved for the first SCSI device in the chain. Use a number
between 1 and 6 for the CDR200t. Refer to the diagram below for
more information on setting the SCSI ID number. The factory set ID
number is “3”.
Important:
If you are using other SCSI devices, be sure to use a unique ID num-
ber for each device.
Note:
When you are using Windows 95, and if the SCSI ID setting on the
rear panel is the same as the number assigned to another SCSI device,
the Plug and Play component of Windows 95 will automatically
assign an unused number to the CDR200t (SCAM protocol level 1).
124
SCSI ID 1
124
SCSI ID 2
124
SCSI ID 3
124
SCSI ID 4
124
SCSI ID 5
124
SCSI ID 6
124
SCSI ID 7
SCSI ID Setting
124
SCSI ID 0