Filter
Top Products
Chapter 2 - Installing the Yamaha CDR200t Drive
5
Chapter 2 - Installing the Yamaha CDR200t Drive
CDR200t drive settings
Before installing the CDR drive into your computer, you will need to
set the following jumpers. You set these jumpers by inserting jumper
connectors into the jumper switch located on the rear panel of the
CDR drive switch.
♦
SCSI ID settings
♦
Parity setting
♦
Terminator setting
♦
Block size setting
Important:
Use long-nose pliers to remove or insert jumper connectors.
Rear Panel
Jumper Switch
RGL
AUDIO OUT
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
GL
OUT
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SCSI IN
PIN 11
PIN 12
PIN 1
PIN 2