Filter
Top Products
Chapter 2 - Installing the Yamaha CDR200t Drive
8
♦
Block size setting
Block size ON
(with a jumper)
— Block Size is set to 512Byte/sector. This function is valid only for
workstations, such as those that run UNIX.
Block size OFF
(without a jumper)
—
Normally, use this setting.
Cable Connection
SCSI cable
Connect a SCSI cable to the SCSI INTERFACE CONNECTOR on
the rear panel of the CDR200t.
At this time, make sure that figure “1” on upper right corner of
the connector will match the red line on the SCSI cable.
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Block Size ON Block Size OFF
RGL
AUDIO OUT
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
SER. NO.
SCSI INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V