Yamaha CC-5 Speaker System User Manual


 
12
34
5
6
7
8
9
0
CLEAR
CALL
+
TIME
PROG
REPEAT
CD
BAND
TUNER
HALL
JAZZ CLUB
ROCK CNCT
OFF
POWER
AUX
DAT
VOLUME
TAPE
-
b
a
10
+
12
34
5
6
7
8
9
0
+
10
COMPACT DISC OPERATION
E-14
Precautions
If the disc is damaged, dirty or loaded upside down, the
display will show error signs as follows:
* “no disc” is displayed.
* The total track number or “01” is not displayed.
Clean, replace or load the disc properly.
If TV or radio interference occurs during CD operation,
move the unit away from the TV or radio.
Subjecting the unit to shock or vibration can cause
mistracking.
Playing some compact discs at high volume can cause
mistracking. In this case, listen at lower volume.
Do not push the disc table while it is moving.
Press the open/close button if your finger, a disc or other
object is caught by the table. (The table closing operation
will stop after 4 seconds even if the open/close button is
not pressed. At this time, “Er 0:00” appears in the display.)
If the power fails while the table is open, wait until the
power supply returns or gently push the table manually to
close it.
The temperature range for playing compact discs is
recommended to be 5°C (41°F) – 35°C (95°F).
Direct-selection play
By using the track number input buttons on the remote
control transmitter, any track you wish to listen to can be
played directly.
Use the track number input buttons to select the desired
track number. Play will begin automatically.
A. For example, to choose selection 12
(1)Press the “+10” button.
(2)Within 3 seconds, press “2” button.
B. For example, to choose selection 20
(1)Press the “+10” button.
(2)Within 3 seconds, press the “+10” button again.
(3)Within 3 seconds, press the “0” button.
Note
A track number higher than the number of tracks on the disc
cannot be selected. Also, if a higher track number is selected
while the disc table is open, play will begin from track 1 when
the disc table is closed.