Filter
Top Products
1 While the station frequency indicator on the tuner or the
“ON TIME” indicator is lit, press the DISPLAY button to
display the time.
2 While pressing the TIME ADJUST button, press the
HOUR button and set the hour.
* Press the HOUR button once to advance the time by 1
hour. Press and hold to advance continuously.
3 While pressing the TIME ADJUST button, press the
MINUTE button and set the desired time.
* Press the MINUTE button once to advance the time by
1 minute. Press and hold to advance continuously.
* The hour setting will not advance even if minutes
advance from “59” to “00”.
4 Release the TIME ADJUST button to start the clock at the
correct time.
* The clock starts operating from “0” seconds. (Seconds
are not displayed.)
In the event of a power failure or when the AC supply
lead is disconnected.
The clock display will go out.
When the AC power supply is resumed, the clock display will
flash on and off to indicate that the time must be reset.
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface.
Follow the guidelines below for maximum enjoyment from
your CD collection and player.
•
Do not write on either side of the disc, particularly the non-
label side. Signals are read from the non-label side. Do
not mark this surface.
•
Keep your discs away from direct sunlight, heat and
excessive moisture.
•
Always hold the CDs by the edges. Fingerprints, dirt or
water on the CDs can cause noise or mistracking. If a CD
is dirty or does not play properly, clean it with a soft, dry
cloth, wiping straight out from the centre, along the radius.
DISPLAY
TUNING
HOUR
MINUTE
MEMORY
TIME ADJ
FM MODE
CLEAR
TUNING
HOUR
MINUTE
MEMORY
TIME ADJ
FM MODE
CLEAR
TUNING
HOUR
MINUTE
MEMORY
TIME ADJ
FM MODE
CLEAR
E-12
COMPACT DISC OPERATION
SETTING THE CLOCK
Europe model uses an “00:00” 24-hour display.
Changes.
Changes.
1
2
3
4