Filter
Top Products
CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 123
❑ HDMI OUT1, HDMI OUT2
Enables/disables the audio output from a TV connected to the HDMI OUT 1 jack or
HDMI OUT 2 jack.
Settings
• The HDMI OUT 1–2 jacks output 2-channel audio signals when the unit is turned on.
■ Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when the
unit is in standby mode. If this function is set to “On”, you can use the input selection
keys (AV 1–7 and V-AUX) to select an HDMI input even when the unit is in standby
mode (the standby indicator on the unit blinks).
Settings
• This setting is available only when “HDMI Control” is set to “Off”.
Network
Configures the network settings.
■ IP Address
Configures the network parameters (such as IP address).
❑ DHCP
Select whether to use a DHCP server.
Settings
■ Manual network settings
1
Set “DHCP” to “Off”.
2
Use the cursor keys (q/w) to select a parameter type and press ENTER.
3
Use the cursor keys (e/r) to move the edit position and the cursor keys (q/w) to
select a value.
4
To confirm the setting, press ENTER.
5
To configure another network parameter, repeat steps 2 to 4.
Off (default) Disables the audio output from the TV.
On Enables the audio output from the TV.
Off (default) Does not output videos/audio to the TV.
On
Outputs videos/audio to the TV.
(The unit consumes more power than when “Off” is selected.)
Off
Does not use a DHCP server. Configure the network parameters
manually. For details, see “Manual network settings”.
On (default)
Uses a DHCP server to automatically obtain the unit’s network
parameters (such as IP address).
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.