Filter
Top Products
Please have the sample CDG demo disc provided with your Singing Machine playing in the
Singing Machine when you are making these connections so you will see the lyrics on the
screen as soon as you have the setup completed correctly.
You must specify the source you wish to view when you are connecting the video out from the
Singing Machine to either a TV or a VCR. Every TV and VCR manufacturer accomplishes the
set-up a little differently. Even though every TV and VCR is a little different, the general idea is
the same - if you have two sources of video signal (cable or antenna and Singing Machine), you
have to specify which one is displayed on the screen.
If you have never used the video input RCA jack on your TV/VCR you should consult your
TV/VCR user guide. If you don’t have the manual for your TV or VCR, we suggest calling the
customer service department for your manufacturer. They will be able to tell you very quickly
how to configure your TV or VCR to display the video connection.
The three most common ways to set up the TV/VCR are:
1) A ‘Video’ button may be on the TV/VCR or on the remote control. Pressing ‘Video’ may
display the input from your Singing Machine.
2) Try looking for a ‘Video’ channel between the regular channels on your TV/VCR. Do this by
setting the channel on the TV/VCR to channel 2 then pressing the ‘Down’ channel button to
see if there is a ‘Video In’ or ‘Line In’ between the lowest channel and the highest channel on
your system.
3) The configuration may also be located in the set-up menu on the TV/VCR. Look for a section
on ‘Input Selection’ where you might be able to choose the input source i.e. ‘Cable/Ant.’,
‘Video 1’, ‘Line In’ or ‘Video In’.
DC JACK OPERATION: 12V to 14V maximum.
A DC jack is provided for external DC power for use in a car, boat or RV. Please be sure that
inside of the jack is connected to ⊕ 12V side and the outside of jack is connected to , negative
side battery. 12 volts fuse protected lighter style plug extension cord with adapter is
recommended.
MAKING THE CONNECTIONS
negative “-”, OD = 5.5mm
positive “+”, ID = 2.0mm
E9
ENGLISH