Filter
Top Products
TechniSat ST 6002 S
5 Brief Introduction
We have condensed the most important steps for the installation and use of the ST 6002 S. More
detailed information can be found in chapters 6 - 10 of this manual.
It is essential that a high quality outside unit with Triple-Band-LNB is used. If another kind of LNB is
used, the procedure is the same, but you will not be able to receive all satellites.
5.1 Installation
5.1.1 Connection of Outside Unit and TV
Connect your ST 6002 S to
the LNB of the outside unit
using suitable coaxial cable
(eg. TechniSat coaxsat 1750).
Connect the actuator power
cable to the M1/M2 sockets
and the actuator sensor cable
to the "Pulse" and "GND"
sockets.
The polariser should be lin-
ked via the "Ferrite +/-" sockets.
To connect your television to
the ST 6002 S you should use
a euroscart cable. The TV set
should be set correspondingly
to AV.
Alternatively, you can connect
the appliance to your TV at
the UHF/VHF input socket via
UHF antenna cable. If this
connection is made you should
first of all switch to "TSG" on
the back panel of the ST 6002 S and tune your TV set to channel 36, at which point the test signal
(two vertical white stripes) will appear on the screen. Then return the switch to "Video" on the back
panel.
NOTE: The satellite receiver is preset to channel 36. If channel 36 is already occupied by a terrestri-
al channel it is possible to alter the output channel in the range fom 35 - 44. This can be done using
8
RF IN
CH
UHF OUT
+
-
LNB PWR OUT
DC 14/18V
400 mA MAX
(
(
I
B/G
TSG
VIDEO
ANT IN
B(R)-AUDIO-(L)A
DECODER VIDEO
EURO SCART FOR VCR/DECODER
EURO SCART FOR TV
GND PULSE +5V M2 M1
50 mA MAX 36V 1,5 A MAX
EXT BUS
+ FERRIT –
82 ohm, ± 45 mA MAX
220V 240V
F1
F2
FUSE
250V T500mA
FUSE
250V T500mA
AC 240V 50 Hz
110 WATTS MAX
TESTSIGNAL
VIDEO
POLARIZER
LNB
MOTOR
IMPULS-
GEBER
FERNSEH-
ANTENNE
ANTENNEN-
KABEL
SCARTKABEL
FERNSEH-
ANTENNE
MOTOR
IMPULS-
GEBER
Pulse
Generator
TV Antennae
TV Antennae
Antenna
Cable
Sensor
Cable
Power
Cable
Scart Cable